Indian

Sarva Pindi

Telangana rice-flour pan bread studded with soaked chana dal, peanuts and sesame, with pierced holes and a slowly crisped base.

November 20, 2026

Share
Sarva Pindi
Prep
20 minutes
Cook
35 minutes
Serves
4
Level
medium

Sarva pindi is a Telangana rice-flour bread pressed into a pan with pulses, seeds and aromatics. Its holes let small amounts of oil reach the pan beneath the dough. The result should have a crisp golden base and a cooked, slightly tender centre.

Makes two 22 cm discs, cut into four snack portions. Use two cool nonstick or well-seasoned shallow pans, or let one pan cool fully between batches. The total includes a two-hour dal soak and ten-minute dough rest, with chopping during the soak. Cooking both discs together takes about 20 minutes; the estimate allows sequential batches plus a short pan-cooling interval.

Ingredients

  • 30 g chana dal
  • 250 g fine rice flour
  • 30 g roasted unsalted peanuts, roughly crushed
  • 1 tablespoon white sesame seeds
  • 80 g onion, very finely chopped
  • 1 small green chilli, finely chopped
  • 10 g ginger, grated
  • 2 garlic cloves, crushed
  • 8 curry leaves, finely sliced
  • 1/2 teaspoon cumin seeds
  • 1/2 teaspoon mild red chilli powder
  • 3/4 teaspoon fine salt
  • 220 ml warm water, plus up to 50 ml more as needed
  • 3 tablespoons neutral oil, divided

Instructions

Soak the dal. Rinse chana dal and cover generously with water for two hours. Drain well. A soaked piece should split under firm pressure; if the centre is still very hard, soak longer. This helps the pulses cook before the bread's base burns.

Mix a soft dough. Combine rice flour, drained dal, peanuts, sesame, onion, chilli, ginger, garlic, curry leaves, cumin, chilli powder and salt. Add 1 tablespoon oil and 220 ml warm water. Mix and knead briefly, adding more water by the tablespoon until the dough is soft enough to press without deep cracks. Cover for ten minutes.

Press in a cool pan. Divide the dough in two. Coat a cool 22–24 cm pan with 1 teaspoon oil. With damp fingers, press one portion evenly into a disc about 4–5 mm thick. Make seven to nine fingertip-sized holes right through to the pan. Drizzle 1 teaspoon oil around the edge and another into the holes. Repeat in the second cool pan when ready.

Seasoned rice-flour dough pressed evenly into a cool oiled pan with distinct holes

Cook slowly. Put the pan over medium-low heat and cover for 8–10 minutes. Uncover and continue for 4–6 minutes until the surface looks set, oil gently bubbles in the holes and the edge releases. Lift an edge with a thin spatula: the base should be golden, not dark brown.

Oil gently bubbling through the holes while the rice-flour bread sets and crisps

Finish and check. Loosen the whole disc. Turn it carefully and cook uncovered for 2–3 minutes if you want both sides crisp. Break a small piece near the centre: the flour should be cooked through without a chalky layer, and the dal tender enough to bite. If the base browns too quickly, reduce the heat and finish covered for a few extra minutes. Use the remaining oil for the second disc, allowing a reused pan to cool before pressing dough into it.

Serving and sources

Serve warm with Coconut Chutney. These pressed dough discs offer a different pan technique from the pourable batter of Korean Scallion Pancakes. If the dough cracks, wet your fingers and smooth it; if sticky and pasty, work in a spoonful more flour before shaping.

Kamareddy district's culinary guide documents the Telangana preparation and characteristic holes. ICAR's Traditional Rice Foods includes sarva pindi with soaked Bengal gram. NDTV's method provides a further pan-cooking reference. This version uses measured dough thickness and a cool pan for shaping.

#telangana#rice-flour#pan-bread#vegan#snack

You might also like